Fabric OS Administrator’s Guide 489
53-1002745-02
Ports on Demand
18
After a port is assigned to the POD set, the port is licensed until it is manually removed from the
POD port set. When a port is released from its POD port set (Base, Single, or Double), it creates a
vacancy in that port set.
Use the following procedure to release a port from a POD set:
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the switchDisable command to take the switch offline.
switch:admin> switchdisable
3. Enter the switchShow command to verify the switch state is offline.
4. Enter the licensePort
--release command to remove the port from the POD license.
switch:admin> licenseport --release 0
5. Enter the licensePort --show command to verify the port is no longer assigned to a POD set.
switch:admin> licenseport --show
24 ports are available in this switch
Full POD license is installed
Dynamic POD method is in use
24 port assignments are provisioned for use in this switch:
12 port assignments are provisioned by the base switch license
12 port assignments are provisioned by a full POD license
10 ports are assigned to installed licenses:
10 ports are assigned to the base switch license
0 ports are assigned to the full POD license
Ports assigned to the base switch license:
1*, 2*, 3*, 4*, 5*, 6*, 8*, 21, 22, 23
Ports assigned to the full POD license:
None
Ports not assigned to a license:
0, 7, 9, 10, 11, 12, 13, 14, 15, 16, 17, 18, 19, 20
6. Enter the switchEnable command to bring the switch back online.
7. Enter th e switchShow command to verify the switch state is now online.
To Next Page
Loading...
