Using the StoreOnce CLI to identify a problem
Overview
The following StoreOnce CLI commands can also be used to identify hardware problems and to navigate the
hardware tree for details about a specific component.
• hardware show problems
• hardware show status <Dev-id>
The following example illustrates how to use the StoreOnce CLI commands to find out more about the disk
problems we have identified on the StoreOnce GUI. See the HPE StoreOnce CLI Reference Guide for more
details.
Identifying a problem
Procedure
1. To display warnings for all hardware components, run the StoreOnce CLI command:
hardware show problems
The output of this command will assist you in identifying the storage cluster and component that is causing
a problem.
2. To drill down to the hardware component causing the problem run the StoreOnce CLI command,
hardware show status <Dev-id> iteratively, where <Dev-id> is the component with a DEGRADED
status until the required component is displayed (it will have a status of FAILED or MISSSING). For
example:
# hardware show status
Name Dev-id Status
-------------------- ------------------------------------ --------
HPXXXNNNNNNS 37373937-3133-5A43-4A34-333530333553 DEGRADED
p1224 Storage System 051dbf3f-0000-1000-8017-533646303433 DEGRADED
# hardware show status 051dbf3f-0000-1000-8017-533646303433
Name Dev-id Status
-------------------- ------------------------------------ --------
22 Using the StoreOnce CLI to identify a problem
To Next Page
Loading...
Need help?
General