a. Log on to the iLO4 GUI.
b. Select the Administration Tab.
c. Select Licensing and enter the recorded license key in the section marked Enter License Activation
Key.
13. Use the StoreOnce GUI or StoreOnce CLI to check that the firmware on the new component is correct.
NOTE:
Note the output after running firmware upgrade. It will advise if you need a system reboot or a cold
reboot to install the new firmware revision successfully.
14. After power-up, it is necessary to rewrite warranty serial numbers into BIOS. Contact HPE Support for
assistance in rewriting warranty serial numbers.
RBSU settings
Table 14: RBSU settings for HPE StoreOnce 3100 System
Top menu item Sub menu 1 Sub menu 2 Current default
state
Change to–
Boot options Boot Mode UEFI Mode Legacy BIOS mode
Power Management
Options
HP Power Profile Balanced Power
and Performance
Maximum
performance
Advanced Options Advanced System
ROM Option
Product ID 794750-B21
Thermal
configuration
Optimal Cooling Increased cooling
Date and Time Time (hh:mm:ss) As appropriate
Time zone UTC-07:00,
Mountain Time (US
& Canada)
As appropriate
BIOS Serial
Console and EMS
BIOS Serial
Console Port
Auto Physical
USB Options Embedded User
Partition
Disabled Only if 'enabled' in
the first place
RBSU settings 49
To Next Page
Loading...
Need help?
General