111
Step Command Remarks
port-number [ tos tos ]
• UDP listening service:
nqa server udp-echo ip-address
port-number [ tos tos ]
packets sent by the NQA
server. The default ToS
value is 0.
Enabling the NQA client
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enable the NQA client.
nqa agent enable
By default, the NQA client is enabled.
Configuring NQA operations on the NQA client
NQA operation configuration task list
Tasks at a glance
(Required.) Perform at least one of the following tasks:
• Configuring the ICMP echo operation
• Configuring the DHCP operation
• Configuring the DNS operation
• Configuring the FTP operation
• Configuring the HTTP operation
• Configuring the UDP jitter operation
• Configuring the SNMP operation
• Configuring the TCP operation
• Configuring the UDP echo operation
• Configuring the UDP tracert operation
• Configuring the voice operation
• Configuring the DLSw operation
• Configuring the path jitter operation
(Optional.) Configuring optional parameters for the NQA operation
(Optional.) Configuring the collaboration feature
(Optional.) Configuring threshold monitoring
(Optional.) Configuring the NQA statistics collection feature
(Optional.) Configuring the saving of NQA history records
(Required.) Scheduling the NQA operation on the NQA client
Configuring the ICMP echo operation
The ICMP echo operation measures the reachability of a destination device. It has the same function
as the ping command, but provides more output information. In addition, if multiple paths exist
To Next Page
Loading...
Need help?
General
