114
Step Command Remarks
4. Specify the IP address of
the DNS server as the
destination address of DNS
packets.
destination ip
ip-address
By default, no destination IP
address is specified.
5. Specify the domain name
that needs to be translated.
resolve-target
domain-name
By default, no domain name is
specified.
Configuring the FTP operation
The FTP operation measures the time for the NQA client to transfer a file to or download a file from
an FTP server.
When you configure the FTP operation, follow these restrictions and guidelines:
• When you perform the put operation with the filename command configured, make sure the file
exists on the NQA client.
• If you get a file from the FTP server, make sure the file specified in the URL exists on the FTP
server.
• The NQA client does not save the file obtained from the FTP server.
• Use a small file for the FTP operation. A big file might result in transfer failure because of
timeout, or might affect other services for occupying much network bandwidth.
To configure the FTP operation:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create an NQA operation
and enter NQA operation
view.
nqa
entry
admin-name
operation-tag
By default, no NQA operation is created.
3. Specify the FTP type and
enter its view.
type ftp
N/A
4. Specify the URL of the
destination FTP server.
url
url
By default, no URL is specified for the
destination FTP server.
Enter the URL in one of the following
formats:
• ftp://host/filename.
• ftp://host:port/filename.
When you perform the
get
operation, the
file name is required.
5. (Optional.) Specify the
source IP address of FTP
request packets.
source ip
ip-address
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no FTP
requests can be sent out.
6. Specify the FTP operation
type.
operation
{
get
|
put
}
By default, the FTP operation type is
get
,
which means obtaining files from the FTP
server.
7. Specify an FTP login
username.
username
username
By default, no FTP login username is
configured.
8. Specify an FTP login
password.
password
{
cipher
| By default, no FTP login password is
To Next Page
Loading...
Need help?
General
