EasyManuals Logo

HPE FlexFabric 5700 Series User Manual

HPE FlexFabric 5700 Series
314 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
59
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Set the cumulative offset
between the UTC and TAI.
ptp
utc
offset
utc-offset
The default is 0 seconds.
Setting the correction date of the UTC
This task allows you to adjust the UTC at the last minute (23:59) of the specified date.
To set the correction date of the UTC:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Set the correction date of the
UTC.
ptp
utc
{
leap59-date
|
leap61-date
} date
By default, the correction date of
the UTC is not configured.
This command takes effect only
on the GM.
Configuring the parameters of the BITS clock
Clock nodes in a PTP domain exchange announce messages through BMC to elect a GM. They
compare the parameters in the announce messages in the following sequence: priority 1, time class,
time accuracy, and priority 2. If all these parameters are the same, the clock node with a smaller port
ID (consisting of clock number and port number) wins.
To configure the clock parameters
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Configure priority 1 of the
clock.
ptp
priority
clock-source
{
bits1
|
bits2
|
local
}
priority1
pri1-value
Optional.
The default is 128.
3. Configure the parameters of
the BITS clock.
ptp clock-source
{
bits1
|
bits2
}
{
accuracy
acc-value |
class
class-value |
time-source
ts-value }
By default, the time accuracy is
254, the time class is 248, and the
attribute value is 160 for the BITS
clock.
4. Configure the time accuracy
of the BITS clock.
ptp clock-source
{
bits1
|
bits2
}
accuracy
acc-value
Optional.
The default is 254.
5. Configure priority 2 of the
clock.
ptp priority clock-source
{
bits1
|
bits2
|
local
}
priority2
pri2-value
Optional.
The default is 128.
6. Configure the attribute value
of the BITS clock.
ptp clock-source
{
bits1
|
bits2
}
time-source
ts-value
Optional.
The default is 160.

Table of Contents

Other manuals for HPE FlexFabric 5700 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE FlexFabric 5700 Series and is the answer not in the manual?

HPE FlexFabric 5700 Series Specifications

General IconGeneral
Product LineHPE FlexFabric
Model5700 Series
Power SupplyRedundant power supply options
Layer SupportLayer 2/3
ManagementHPE Intelligent Management Center (IMC), CLI, SNMP
Routing ProtocolRIP, OSPF, BGP, IS-IS
FeaturesVirtualization
Compliant StandardsIEEE 802.1D, IEEE 802.1Q, IEEE 802.1w, IEEE 802.1s, IEEE 802.3ad, IEEE 802.3ae
Operating Temperature32°F to 113°F (0°C to 45°C)
Operating Humidity10% to 90% (noncondensing)
LatencyLess than 1 µs

Related product manuals