71
Information center configuration task list
Task at a glance
Perform at least one of the following tasks:
• Outputting logs to the console
• Outputting logs to the monitor terminal
• Outputting logs to a log host
• Outputting logs to the log buffer
• Saving logs to the log file
(Optional.) Managing security logs
(Optional.) Saving diagnostic logs to the diagnostic log file
(Optional.) Configuring the maximum size of the trace log file
(Optional.) Enabling synchronous information output
(Optional.) Enabling duplicate log suppression
(Optional.) Disabling an interface from generating link up or link down logs
(Optional.) Setting the minimum storage time for logs
Outputting logs to the console
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enable the information
center.
info-center enable
By default, the information center
is enabled.
3. Configure an output rule for
the console.
info-center source
{ module-name |
default
}
{
console
|
monitor
|
logbuffer
|
logfile
|
loghost
} {
deny
|
level
severity }
For information about default
output rules, see "Default output
rules for logs."
4. (Optional.) Configure the
timestamp format.
info-center timestamp
{
boot
|
date
|
none
}
By default, the timestamp format
is
date
.
5. Return to user view.
quit
N/A
6. (Optional.) Enable log output
to the console.
terminal monitor
The default setting is enabled.
7. Enable the display of debug
information on the current
terminal.
terminal debugging
By default, the display of debug
information is disabled on the
current terminal.
8. (Optional.) Set the lowest
severity level of logs that can
be output to the console.
terminal logging level
severity
The default setting is 6
(informational).
Outputting logs to the monitor terminal
Monitor terminals refer to terminals that log in to the device through the VTY line.
To Next Page
Loading...
Need help?
General
