HPE FlexFabric 5700 Series User Manual

214
Specifying an SSL client policy for HTTPS connection to ACS
CWMP uses HTTP or HTTPS for data transmission. If the ACS uses HTTPS for secure access, its
URL begins with https://. You must configure an SSL client policy for the CPE to authenticate the
ACS for HTTPS connection establishment. For more information about configuring SSL client
policies, see Security Configuration Guide.
To specify an SSL client policy for the CPE to establish an HTTPS connection to the ACS:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter CWMP view.
cwmp
N/A
3. Specify an SSL client policy.
ssl client-policy
policy-name
By default, no SSL client policy is
specified.
Displaying and maintaining CWMP
Execute display commands in any view.
Task Command
Display CWMP configuration.
display cwmp configuration
Display the current status of CWMP.
display cwmp status
CWMP configuration example
Network requirements
As shown in Figure 3, use HPE IMC BIMS as the ACS to bulk-configure the devices (CPEs), and
assign ACS attributes to the CPEs from the DHCP server.
The configuration files for the devices in equipment rooms A and B are configure1.cfg and
configure2.cfg, respectively.

HPE FlexFabric 5700 Series Specifications

General

Product Line	HPE FlexFabric
Model	5700 Series
Power Supply	Redundant power supply options
Layer Support	Layer 2/3
Management	HPE Intelligent Management Center (IMC), CLI, SNMP
Routing Protocol	RIP, OSPF, BGP, IS-IS
Features	Virtualization
Compliant Standards	IEEE 802.1D, IEEE 802.1Q, IEEE 802.1w, IEEE 802.1s, IEEE 802.3ad, IEEE 802.3ae
Operating Temperature	32°F to 113°F (0°C to 45°C)
Operating Humidity	10% to 90% (noncondensing)
Latency	Less than 1 µs