75
Step Command Remarks
4. Set the interval at which the
system saves security logs.
info-center security-logfile
frequency
freq-sec
By default, the system saves
security logs to the security log file
every 86400 seconds.
5. (Optional.) Set the maximum
size of the security log file.
info-center security-logfile
size-quota
size
By default, the maximum size of
the security log file is 10 MB.
6. (Optional.) Set the alarm
threshold of the security log
file usage.
info-center security-logfile
alarm-threshold
usage
By default, the alarm threshold of
the security log file usage is 80.
When the usage of the security
log file reaches 80%, the system
will inform the user.
Managing the security log file
To use the security log file management commands, a local user must be authorized the
security-audit user role. For information about configuring the security-audit user role, see Security
Command Reference.
To manage the security log file:
Task Command Remarks
Display a summary of the security
log file.
display security-logfile
summary
Available in user view.
Change the directory of the
security log file.
1. system-view
2. info-center
security-logfile directory
dir-name
By default, the security log file is
saved in the
seclog
directory in the
root directory of the storage device.
The configuration made by this
command cannot survive an IRF
reboot or a master/subordinate
switchover.
Manually save all the contents in
the security log file buffer to the
security log file.
security-logfile save
Available in any view.
Saving diagnostic logs to the diagnostic log file
By default, the system saves diagnostic logs from the diagnostic log file buffer to the diagnostic log
file every 24 hours. You can adjust the saving interval or manually save diagnostic logs to the
diagnostic log file. After saving diagnostic logs to the diagnostic log file, the system clears the
diagnostic log file buffer.
The diagnostic log file has a maximum capacity. When the capacity is reached, the system replaces
earliest diagnostic logs with new logs.
To enable saving diagnostic logs to a diagnostic log file:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enable the information
center.
info-center enable
By default, the information center
is enabled.
3. Enable saving diagnostic
logs to the diagnostic log file.
info-center logfile enable
By default, saving diagnostic logs
to the diagnostic log file is
To Next Page
Loading...
