HPE FlexFabric 5700 Series User Manual

23
Multicast server Multicast client
Authentication
result
Enable NTP
authenticatio
n
Configure
a key and
configure
it as a
trusted key
Associate
the key with
a multicast
server
Enable NTP
authenticatio
n
Configure
a key and
configure
it as a
trusted key
received
correctly.
Yes Yes Yes No N/A
Failed. NTP
messages cannot
be sent and
received
correctly.
Yes No Yes Yes N/A
Failed. NTP
messages cannot
be sent and
received
correctly.
Yes No Yes No N/A
No authentication.
NTP messages
can be sent and
received
correctly.
Yes N/A No Yes N/A
Failed. NTP
messages cannot
be sent and
received
correctly.
Yes N/A No No N/A
No authentication.
NTP messages
can be sent and
received
correctly.
No N/A N/A Yes N/A
Failed. NTP
messages cannot
be sent and
received
correctly.
No N/A N/A No N/A
No authentication.
NTP messages
can be sent and
received
correctly.
Configuring NTP optional parameters
The configuration tasks in this section are optional tasks. Configure them to improve NTP security,
performance, or reliability.
Specifying the source interface for NTP messages
To prevent interface status changes from causing NTP communication failures, configure the device
to use the IP address of an interface that is always up, for example, a loopback interface, as the
source IP address for the NTP messages to be sent. Set the loopback interface as the source

HPE FlexFabric 5700 Series Specifications

General

Product Line	HPE FlexFabric
Model	5700 Series
Power Supply	Redundant power supply options
Layer Support	Layer 2/3
Management	HPE Intelligent Management Center (IMC), CLI, SNMP
Routing Protocol	RIP, OSPF, BGP, IS-IS
Features	Virtualization
Compliant Standards	IEEE 802.1D, IEEE 802.1Q, IEEE 802.1w, IEEE 802.1s, IEEE 802.3ad, IEEE 802.3ae
Operating Temperature	32°F to 113°F (0°C to 45°C)
Operating Humidity	10% to 90% (noncondensing)
Latency	Less than 1 µs