EasyManuals Logo

HPE FlexFabric 5700 Series User Manual

HPE FlexFabric 5700 Series
314 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
13
Step Command Remarks
interface-type
interface-number ] *
Configuring NTP in symmetric active/passive mode
When the device operates in symmetric active/passive mode, specify on a symmetric-active peer the
IP address for a symmetric-passive peer.
Follow these guidelines when you configure a symmetric-active peer:
Execute the ntp-service enable command on a symmetric passive peer to enable NTP.
Otherwise, the symmetric-passive peer will not process NTP messages from a
symmetric-active peer.
Either the symmetric-active peer, or the symmetric-passive peer, or both of them must be in
synchronized state. Otherwise, their time cannot be synchronized.
You can configure multiple symmetric-passive peers by repeating the ntp-service
unicast-peer or ntp-service ipv6 unicast-peer command.
To configure a symmetric-active peer:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Specify a symmetric-passive
peer for the device.
Specify a symmetric-passive
peer:
ntp-service unicast-peer
{ peer-name | ip-address }
[ authentication-keyid keyid
| priority | source
interface-type
interface-number | version
number ] *
Specify an IPv6
symmetric-passive peer:
ntp-service ipv6
unicast-peer { peer-name |
ipv6-address }
[ authentication-keyid
keyid | priority | source
interface-type
interface-number ] *
By default, no symmetric-passive
peer is specified.
Configuring NTP in broadcast mode
A broadcast server must be synchronized by other devices or use its local clock as a reference
source before synchronizing a broadcast client. Otherwise, the broadcast client will not be
synchronized to the broadcast server.
Configure NTP in broadcast mode on both broadcast server and client.
Configuring a broadcast client
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
Enter the interface for receiving
NTP broadcast messages.

Table of Contents

Other manuals for HPE FlexFabric 5700 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE FlexFabric 5700 Series and is the answer not in the manual?

HPE FlexFabric 5700 Series Specifications

General IconGeneral
Product LineHPE FlexFabric
Model5700 Series
Power SupplyRedundant power supply options
Layer SupportLayer 2/3
ManagementHPE Intelligent Management Center (IMC), CLI, SNMP
Routing ProtocolRIP, OSPF, BGP, IS-IS
FeaturesVirtualization
Compliant StandardsIEEE 802.1D, IEEE 802.1Q, IEEE 802.1w, IEEE 802.1s, IEEE 802.3ad, IEEE 802.3ae
Operating Temperature32°F to 113°F (0°C to 45°C)
Operating Humidity10% to 90% (noncondensing)
LatencyLess than 1 µs

Related product manuals