256
Operation Description XML example
• If the specified target does
not exist and it cannot be
created, an error message
is returned.
xmlns="http://www.h3c.com/netconf/config:1
.0" xc:operation="merge">
<LogBuffer>
<BufferSize>120</BufferSize>
</LogBuffer>
</Syslog>
</top>
</config>
</edit-config>
</rpc>
edit-config: create
Creates a specified target. To
use the create attribute in an
<edit-config> operation, you
must specify the operation
target.
• If the table supports target
creation and the specified
target does not exist, the
operation creates and then
configures the target.
• If the specified target
exists, a data-exist error
message is returned.
The XML data format is the same as the edit-config
message with the merge attribute. Change the
operation attribute from
merge
to
create
.
edit-config:
replace
Replaces the specified target.
• If the specified target
exists, the operation
replaces the configuration
of the target with the
configuration carried in the
message.
• If the specified target does
not exist but is allowed to
be created, create the
target and then apply the
configuration of the target.
• If the specified target does
not exist and is not allowed
to be created, the operation
is not conducted and an
invalid-value error
message is returned.
The syntax is the same as the edit-config message
with the merge attribute. Change the operation
attribute from
merge
to
replace
.
edit-config:
remove
Removes the specified
configuration.
• If the specified target has
only the table index, the
operation removes all
configuration of the
specified target, and the
target itself.
• If the specified target has
the table index and
configuration data, the
operation removes the
specified configuration data
of this target.
The syntax is the same as the edit-config message
with the merge attribute. Change the operation
attribute from
merge
to
remove
.
To Next Page
Loading...
