Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• T-10 Torx screwdriver
• T-15 Torx screwdriver
Procedure
1. If installed, remove the front bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack.
6. Remove the left inner rail.
7. Remove the access panel.
8. Remove the air baffle.
9. If installed, remove one of the following items:
• Secondary riser cage blank
Hardware options installation 111
To Next Page
Loading...
