20. Install the air baffle.
21. Install the access panel.
22. Install the server into the rack.
23. Connect all peripheral cables to the server.
24. Connect each power cord to the server.
25. Connect each power cord to the power source.
26. Power up the server on page 43.
27. If removed, install the front bezel.
The installation is complete.
Optical drive cage and optical drive options
Installing the optical drive in the LFF chassis
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
•
T-10 Torx screwdriver
• T-15 Torx screwdriver
Procedure
1. If installed, remove the front bezel.
2. Power down the server.
3. Remove all power:
Hardware options installation 71
To Next Page
Loading...
