HPE ProLiant DL180

Hardware options installation
This chapter provides detailed instructions on how to install hardware options.
For more information on supported options, see the product QuickSpecs on the website at:
http://www.hpe.com/info/qs
To view the warranty for your server and supported options, see Warranty information on page 169.
Introduction
Install any hardware options before initializing the server. For options installation information, see the
option documentation. For server-specific information, use the procedures in this section.
If multiple options are being installed, read the installation instructions for all the hardware options to
identify similar steps and streamline the installation process.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal
system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before
beginning any installation procedure. Improper grounding can cause electrostatic discharge.
Installing the bezel and the bezel lock
Procedure
1. Install the bezel.
a. Attach the bezel to the right latch ear.
b. Press the latch on the bezel.
c. While pressing the latch, rotate the bezel to attach bezel to left latch ear.
2. Install the Kensington lock.
Hardware options installation 55