14. Install the riser cage.
15. Ensure that the GPU bracket is secured with the latch on the air baffle.
16. Connect the power cable to GPU installed in secondary riser cage.
17. Install the access panel.
18. Install the server into the rack.
19. Connect all peripheral cables to the server.
20. Connect each power cord to the server.
21. Connect each power cord to the power source.
22. Power up the server on page 43.
The installation is complete.
Installing the FlexibleLOM adapter
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• T-15 Torx screwdriver
• T-10 Torx screwdriver
• FlexibleLOM riser cage
Procedure
1. If installed, remove the front bezel.
2. Power down the server.
3. Remove all power:
Hardware options installation 103
To Next Page
Loading...
