23. Connect each power cord to the power source.
24. Power up the server on page 43.
The installation is complete.
Installing a GPU card
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure
1. If installed, remove the front bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
•
Extend the server from the rack.
• Remove the server from the rack.
6. Remove the access panel.
7. Remove the air baffle.
8. If installed, remove one of the following components:
• Primary riser cage
• Secondary riser cage blank
100 Hardware options installation
To Next Page
Loading...
