9. Disconnect existing drive power cable.
10. Connect the NVMe signal and power cables.
11. Install the NVMe drives.
12. Install the air baffle.
13. Install the access panel.
14. Install the server into the rack.
15. Connect all peripheral cables to the server.
16. Connect each power cord to the server.
17. Connect each power cord to the power source.
18. Power up the server on page 43.
19. If removed, install the front bezel.
The installation is complete.
Installing the 8 to 12 upgrade option in the LFF chassis
The 8 LFF chassis can be upgraded to 12 LFF chassis with this option installed. This option cannot be
installed when the NVMe drive cage is installed in the box 1.
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• T-10 Torx screwdriver
• Flat-headed screwdriver
Hardware options installation 67
To Next Page
Loading...
