6. Install the rack rail hook-and-loop strap:
a. Hold the rear panel cables against the rack rail, and then wrap the strap around the rack rail.
CAUTION: Prevent the thermal or mechanical obstruction on full-length servers installed in
the rack. Ensure that the extra length and buckle part of the strap must be facing the outside
of the rack rail.
b. Loop the end of the hook-and-loop strap through the buckle.
When multiple hook-and-loop straps are used in the same rack, stagger the strap location. Ensure that
the straps are adjacent to each other when viewed from top to bottom. This positioning will enable the
rack rail to slide easily in and out of the rack.
7. Secure the cables to the cable management arm.
Setup 39
To Next Page
Loading...
