HPE ProLiant MicroServer Gen10 Series User Manual

c. Install the chassis cover on page 19.
Remove the chassis cover
To access the front bezel lock and the internal components, remove the chassis cover.
Procedure
1. If installed, unlock and remove the security padlock and/or the Kensington security lock.
For more information, see the lock documentation.
2. Remove the chassis cover thumbscrews.
If the thumbscrews are too tight, use a T-15 screwdriver to remove it.
3. Slide the chassis cover toward the rear panel, and then lift it from the server.
Install the chassis cover
To prevent access to the front bezel lock and the internal components, install the chassis cover.
Remove the chassis cover 19

HPE ProLiant MicroServer Gen10 Series Specifications

General

Product Line	HPE ProLiant MicroServer
Processor	AMD Opteron X3000 Series
Memory Slots	2
Networking	2x 1GbE ports
Memory	Up to 32 GB DDR4 UDIMM
Storage	4 LFF SATA HDD bays (3.5-inch)
RAID Support	RAID 0, 1
Power Supply	200W non-redundant power supply
Management	HPE iLO 5 Standard
Form Factor	Micro Tower
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Weight	Approx. 6.5 kg