Figure 4-84 Position of the cables to the pressure announciator
Step 4 Remove the high-pressure hose and adapter of the re cylinder using an
adjustable wrench, as shown by (1) and (2) in Figure 4-85.
Figure 4-85 Removing the high-pressure hose and adapter
Step 5 Loosen the straps on the re cylinder.
Step 6 Move the
re cylinder out of the installation position.
Step 7 Move the new re cylinder to the installation position using a pallet truck, and
tighten the re cylinder steel straps.
● Do not impact or strike the re cylinder during transportation or installation.
● Assign
sucient people for transportation and installation if no auxiliary tool is
available.
● Keep the pressure gauge panel outward so that people can view the reading.
FusionDC1000A Prefabricated All-in-One Data
Center
Maintenance Guide (IT Scenario) 4 Parts Replacement
Issue 01 (2021-04-20) Copyright © Huawei Technologies Co., Ltd. 138
To Next Page
Loading...
