FusionModule800 Smart Small Data Center
Installation Guide (Six Fans)
Copyright © Huawei Technologies Co., Ltd.
Obtain the paper documents about the smart cooling product and UPS from the fitting box.
2. Check the cabinet exterior for damage. If any damage is found, notify the carrier
immediately.
3. Check against the packing list that the equipment and fittings are correct and complete. If
some fittings are missing or do not comply with the packing list, record the information
and contact your local Huawei office immediately.
4. After checking that the Converged Cabinet is intact, remove the L-shaped brackets that
secure the cabinet to the pallet.
a. Open the front and rear doors of the cabinet, and remove the cabinet lower sealing
plates.
b. Remove the L-shaped brackets.
c. Reinstall the cabinet lower sealing plates, and close the front and rear doors of the
cabinet.
Figure 3-2 Removing the cabinet lower sealing plates
To Next Page
Loading...
Need help?
General