iManager NetEco 6000
Device Installation and Commissioning Guide
Copyright © Huawei Technologies Co., Ltd.
Figure 6-7 Login page
Figure 6-8 Home page
Step 5 Set CIM parallel parameters.
If multiple CIMs need to be connected to a LAN switch, set Parallel.
The following parameter settings use the parallel CIMs as an example. For operation on a single
CIM, refer to this section.
1. On the CIM WebUI home page, choose Monitoring > CIM System > Running
Parameter > Parallel Configuration, and select Parallel.
Figure 6-9 Setting parameters for the parallel system
To Next Page
Loading...
Need help?
General