Parameter Code Parameter Name Description
24 State If the access challenge packet
that the RADIUS server sends to
a device contains this parameter,
the subsequent access request
packet sent by the device to the
RADIUS server must also
contain this parameter of the
same value as that is contained in
the access challenge packet.
25 Class If the access accept packet sent
by the RADIUS server to a
device contains this parameter,
the subsequent charging request
packet sent by the device to the
RADIUS server must also
contain this parameter of the
same value.
For a standard RADIUS server, a
device can use the Class attribute
to represent the CAR parameter.
27
Session-Timeout Indicates the available remaining
time in the unit of second. It is the
user re-authentication time in the
EAP challenge packet.
29 Termination-Action Indicates the service termination
mode. The valid modes are re-
authentication and forcing users
to go offline.
31 Calling-Station-Id Allows the NAS to send the
calling number.
32 NAS-Identifier Indicates the host name of the
device.
40 Acct-Status-Type Indicates the charging packet
type.
l 1: charging start packet
l 2: charging stop packet
l 3: real-time charging packet
41 Acct-Delay-Time Indicates the time for generating
a charging packet in the unit of
second.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide 2 Basic Configurations
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
231
To Next Page
Loading...
Need help?
General
