EasyManuals Logo

Huawei SmartAX MA5600T User Manual

Huawei SmartAX MA5600T
1979 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
l For details about how to log in to the MA5600T/MA5603T/MA5608T by using the local
serial port, see 1.3.5.1 Login Through the Local Serial Port.
l For details about how to log in to the MA5600T/MA5603T/MA5608T by using the ETH
port, see the following:
– Configure the IP address of the PC that is used for logging in to the MA5600T/
MA5603T/MA5608T. This IP address is on the same subnet as the IP address of the
maintenance Ethernet port but is not the IP address of the maintenance Ethernet port.
For example, configure the IP address to 10.11.104.6.
– After logging in to the MA5600T/MA5603T/MA5608T, run the ip address command
to change the IP address of the device to 10.50.1.10/24.
– Change the IP address of the PC to be on the same subnet as the IP address of the
maintenance Ethernet port but is not the IP address of the maintenance Ethernet port.
For example, change the IP address of the device to 10.50.1.11/24.
Networking
Figure 1-13 shows an example network for outband management through telnet in a LAN, and
Figure 1-14 shows an example network for outband management through telnet in a WAN.
Figure 1-13 Example network for outband management through telnet in a LAN
PC PC
PC
LAN
LSW
Access node
NOTE
The MA5600T/MA5603T/MA5608T is connected to the LAN using the straight using cable, and the IP
address of the maintenance Ethernet port of the MA5600T/MA5603T/MA5608T is in the same network
segment as the IP address of the maintenance terminal. Alternatively, the Ethernet port of the maintenance
terminal can be directly connected to the maintenance Ethernet port of the MA5600T/MA5603T/
MA5608T to manage the MA5600T/MA5603T/MA5608T in the outband management mode. In such a
condition, if the MA5600T/MA5603T/MA5608T uses SCUL/SCUB control board, and the peer device
does not support the cable autosensing function, a crossover cable must be used.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
1 Commissioning
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
27

Table of Contents

Other manuals for Huawei SmartAX MA5600T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei SmartAX MA5600T and is the answer not in the manual?

Huawei SmartAX MA5600T Specifications

General IconGeneral
BrandHuawei
ModelSmartAX MA5600T
CategoryControl Unit
LanguageEnglish

Related product manuals