l Add ONUs offline.
If the password of an ONU is known, run the ont add command to add an ONU offline.
huawei(config)#interface gpon 0/1
huawei(config-if-gpon-0/1)#ont add 0 1 password-auth 0100000001 once-on no-aging
omci ont-lineprofile-name
fttd ont-srvprofile-name fttd
l Confirm automatically discovered ONUs
If the password or SN of an ONU is unknown, run the port portid ont-auto-find enable
command in GPON mode to enable the ONU auto-discovery function of the GPON port.
Then, run the ont confirm command to confirm the ONU.
huawei(config)#interface gpon 0/1
huawei(config-if-gpon-0/1)#port 0 ont-auto-find enable
huawei(config-if-gpon-0/1)#display ont autofind 0
//After this command is executed, the information about all ONUs connected to
the GPON port through optical splitters is displayed.
huawei(config-if-gpon-0/1)#ont confirm 0 ontid 1 password-auth 0100000001 once-
on no-aging omci ont-lineprofile-name
fttd ont-srvprofile-name fttd
NOTE
If multiple ONUs of the same type bound to the same line profile or service profile are connected to the
same port, you can bulk add ONUs by bulk confirming automatically discovered ONUs to make
configuration easier and more efficient. To do so, the preceding command can be modified as follows:
huawei(config-if-gpon-0/1)#ont confirm 0 all password-auth once-on no-aging omci
ont-lineprofile-name fttd
ont-srvprofile-name fttd
NOTE
The password entered when you add an ONU to the OLT must be the same as that configured on the web
page. To configure the password of the ONU on the web page, see Figure 10-11.
Figure 10-11 Modifying ONU password on the web page
l (Optional) Bind the alarm profile to the ONU.
The default profile 1 is used in this example.
huawei(config-if-gpon-0/1)#ont alarm-profile 0 1 profile-id 1
Step 3 Check ONU status.
After an ONU is added, run the display ont info command to query the current status of the
ONU. Ensure that Config flag of the ONU is active, Run State is online, Config state is
normal, and Match state is match.
huawei(config-if-gpon-0/1)#display ont info 0 1
---------------------------------------------------------------------
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
10 FTTD Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
791
To Next Page
Loading...
Need help?
General
