Huawei UA5000 - Page 100

Click OK after the settings.
Step 2 In privilege mode, run the backup data command in TETP mode to back up the files.
When running the backup command, enter the following information:
l Name of the backup file.
l Protocol for the backup.
NOTE
The system supports the system backup through either the serial port or the maintenance network port. The
serial port backup uses the Xmodem protocol; the network port backup uses TFTP or FTP.
For example, to back up the database file to TFTP server (IP: 10.10.1.2) through TFTP, and
specify the name of the file as 20050101.dat, proceed as follows:
huawei#backup data tftp 10.10.1.2 20050101.dat
Step 3 In privilege mode, run the backup configuration command to back up the configuration file.
Example: To back up the configuration file of the system to the TETP server through TETP, and
specify the name of the configuration file saved on the TFTP server (IP: 10.10.1.2) as
20050102.dat, do as follows:
huawei# backup configuration tftp 10.10.1.2 20050102.dat
----End
Result
After backup, the file is backed up successfully in the preset path.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 3 Stand-Alone Commissioning
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
92