l Over-frequent data saving affects the system performance. The recommended saving
interval is 60 minutes or longer.
l Run the save command to save the configuration data no matter whether the auto-save
function is enabled.
Procedure
Step 1 In the common user mode, run the display autosave configuration command to query the status
of the auto-save function. If the system auto-save interval switch is off, proceed to step 2;
otherwise, go to step 3.
NOTE
Saving the data automatically according to the specified interval by the configuration system is considered
as an example in this topic.
Step 2 In privilege mode, run the autosave interval on command to enable the auto-save function of
the system.
NOTE
By default, the auto-save function is disabled.
Step 3 In privilege mode, run the autosave interval time command to set the auto-save interval of the
system.
----End
Result
The auto-save interval is the same as the configuration.
3.18 Saving the Data
This topic describes how to save the data into the flash memory to prevent data loss due to
reboots.
Precaution
WARNING
The system gives prompts during the command execution. Do not power off or reset the system
until the saving process reaches 100%. Otherwise, the data in the flash memory may get
damaged.
Over-frequent saving of the data has negative effect on the system performance.
Procedure
Step 1 In privilege mode, run the save command to save the configuration data of the system into the
flash memory.
----End
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 3 Stand-Alone Commissioning
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
89
To Next Page
Loading...
