Result
l When the database file is saved successfully, the system displays the saving process.
l After the data is saved, the system displays a message 1[YYYY-MM-DD
HH:MM:SS]:PID_DB-4-DBINFO:The configuration data of X slot's main control
board is saved completed . In this message, YYYY-MM-DD HH:MM:SS indicates the
year-month-day hour: minute: second of the current time when the data is saved. X indicates
the slot ID of the control board whose data is saved.
l When no configuration data need to be saved, the system displays a message System
configuration data has been saved completely, no need saving again.
3.19 Backing Up the System File
This topic describes how to back up the system file to prevent permanent data loss due to the
system failure. At the first office deployment or when the upgrade is complete, you need to back
up the database file and the configuration file to restore the system in the case of the system
failure.
Prerequisites
l The network cable must be used to connect the network port of the commissioning terminal
to the maintenance network port of the UA5000.
l The commissioning terminal must be installed with the TFTP software.
Precaution
The UA5000 supports multiple types of backplanes. The backup databases of different control
boards that match different backplanes can not be interoperable, otherwise the data will be in
chaos.
Procedure
Step 1 Run the TFTP program on the commissioning terminal, and set the path for saving the backup
files.
Run the TFTP application, as shown in Figure 3-43.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 3 Stand-Alone Commissioning
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
90
To Next Page
Loading...
