Item Data
Analog parameters ESC analog ID: 0 (name: temperature)
Upper threshold of the temperature alarm: 55
Lower threshold of the temperature alarm: 5
Digital parameters ESC digital ID: 1 (name: door status sensor 0)
Door status sensor: high level
Procedure
Step 1 Adjust the DIP switch of the sub-node for the H303ESC, and set the sub-node number as 30.
Step 2 In global config mode, run the emu add command to add an EMU.
Step 3 In H303ESC mode, run the display esc environment info command to query the current EMU
information and configuration.
Step 4 In H303ESC mode, run the esc analog command to configure the EMU analog parameters.
Step 5 In H303ESC mode, run the esc digital command to configure the EMU digital parameters.
Step 6 In global config mode, run the save command to save the data.
----End
Result
l In H303ESC mode, run the display esc system parameter command to query whether the
EMU information is the same as the configuration.
l Close the cabinet door, and use the display alarm history command to query alarms.
Ensure that no alarm is generated.
3.16.2 Commissioning the Fan EMU
This topic describes how to commission the fan environment monitoring unit (EMU) so that it
can monitor the running status of the device fan.
Prerequisites
l The setting of the DIP switches of the hardware must be consistent with the one of sub-
nodes.
l The device must work in the normal state.
Precaution
The configuration of the fan tray varies with the type of the shelf. The details are as follows:
l The HABA shelf does not support the configuration of the fan tray. The fan monitoring
port is unavailable, and the fan can be controlled by only the dual in-line package (DIP)
switch.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 3 Stand-Alone Commissioning
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
86
To Next Page
Loading...
