Step 4 Click Properties to display the Internet Protocol (TCP/IP) Properties dialog box.
Step 5 Select General and then select Use the following IP address to configure the IP address and
the subnet mask.
Step 6 Click OK to return to the Local Area Connection Properties dialog box.
Step 7 Click OK.
----End
Result
After query, it is found that the IP address of the maintenance terminal is consistent with the IP
address in the data plan.
A.2 Making a Script
This topic describes how to make a script according to the collected data plan.
Script Overview
Before commissioning, you can make the commissioning script according to the data plan
collected in Data Requirements, and then load the script to configure the basic data for the device
so that the device can run normally. In this case, you can test commission the basic functions
and the services of the device.
The basic configuration through the script includes but is not limited to the following items:
l Configuring the environment monitoring unit (including the FAN and the ESC)
l Configuring an MG Interface
NOTE
l For details about how to load the script, see Loading the Script.
l For the information on how to configure the MG interface, see Configuration Example of the MG
Interface (the H.248 Protocol).
Example Script
Table A-1 provides the data plan for configuring the example script. After the example script
is configured, the maintenance terminal in the management center can log in to the UA5000 to
commission the basic functions of the device.
Table A-1 Script data plan
Item
Data
FAN EMU
l SN: 1
l Sub-node: 6
l Name: FAN
l Fan speed adjustment mode: automatic
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI A Additional Information
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
116
To Next Page
Loading...
