NOTE
One hour before the battery charge is over, check the value of the battery voltage one by one. If the battery
voltage is equal to or less than 2.16 V/cell, discharge the battery that has completed charge at the constant
current of 0.25 C
10
A. Ensure that the discharge time is approximately three hours. Then, perform the charge
in the constant voltage and limited current mode based on the preceding procedures of the battery
supplementary charge.
If the battery capacity cannot be restored completely through this charge/discharge cyclic method either,
it indicates that the battery is invalid because it remained unused for a long time or is faulty. In this case,
the battery must be discarded as useless.
----End
A.4 Software Package Settings
This topic describes the software package settings of the UA5000.
A.4.1 Setting the Default System Parameters
The default system parameter settings of the UA5000 are as follows:
Table A-3 System parameters
Parameter
Index
Meaning Default Setting
0 Howler tone sending identifier. 0: not send; 1: send 1: send
1 Overseas version identifier. 0: China; 1: HongKong; 2:
Brazil; 3: Egypt; 4: Singapore; 5: Thailand; 6: France;
7: Britain MSFUK; 8: UK ETSI; 9: Bulgaria
0: China
2 Consistency test identifier. 0: disable; 1: enable 0: disable
3 Stop the initial ringing identifier. 0: not issue; 1: issue 0: not issue
4 System self-check flag. 0: not implement; 1: reset ports
selectively; 2: reset the idle PSTN port
1: resets ports
selectively.
5 CPU overload call restriction identifier (this parameter
is valid for only the V5 and the SPC). 0: not restricted;
1; restricted
0: Not restricted
6 Call waiting tone. 0: played by the MGC; 1: played by
the MG
0: played by the
MGC
7 Message LED mode. 0: voltage ascending mode; 1:
send FSK and ring; 2: send FSK and not ring
0: voltage
ascending mode
9 Reserved parameters 1
10 Whether to support the inconsistency of the IDs for the
peer UDP transmitting and receiving ports. 0: not
support; 1: support
0: not support
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI A Additional Information
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
120
To Next Page
Loading...
