Huawei UA5000 - Login in Telnet Mode (Outband Management)

Figure 3-14 Interface of running the telnet application
Step 4 Log in to the system.
In the remote login dialog box, enter the user name and the password. By default, the user name
is root and the password is admin. After you log in to the system successfully, a message is
displayed indicating that the login is successful, as show in the following message.
>>User name:root
>>User password:
Huawei HONET UA5000 Universal Access Unit.
Copyright(C) 1998-2009 by Huawei Technologies Co.,Ltd.
NOTE
To improve the system security, please modify your password after first login. You can run the terminal user
password command to modify your password.
----End
Result
After logging to the system, you can maintain and manage the UA5000. For the basic information
on how to use the CLI, see CLI Operation Characteristics.
3.5.3 Login in Telnet Mode (Outband Management)
This topic describes how to log in to the UA5000 through the maintenance network port (outband
management port) in telnet mode to maintain and manage the UA5000.
Prerequisites
l You must log in to the UA5000 through the local serial port and the IP address and the
subnet mask must be configured for the UA5000. For detailed configuration, see 3.5.1
Login in the Local Serial Port Mode.
l The IP address of the maintenance terminal has been correctly configured. For the process
of configuring the IP address for the maintenance terminal, see Configuring the IP Address
of the Maintenance Terminal.
NOTE
In the following operations, the configuration of the UA5000 must be performed through the local serial
port.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 3 Stand-Alone Commissioning
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
35