A.1 Configuring the IP Address of the Maintenance
Terminal
This topic describes how to configure the IP address of the maintenance terminal so that the
maintenance terminal can access the UA5000 normally in telnet mode or SSH mode.
Prerequisite
l The maintenance terminal must be connected and started.
l The IP address of the maintenance terminal and the IP address of the device must be at the
same network segment, so that the maintenance terminal can log in to the device to
commission.
Procedure
Step 1 Right-click My Network Places on the desktop, and then choose Properties to display the
Network Connections interface.
Step 2 Right-click Local Area Connection on the Network Connections interface, and then choose
Properties to display the Local Area Connection Properties dialog box.
Step 3 Select General. In the This connection uses the following items pane, select Internet Protocol
(TCP/IP).
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI A Additional Information
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
115
To Next Page
Loading...
