3.8 Configuring the Board
This topic describes how to check whether the inserted board is the same as the board required
in the data plan and check whether the board runs in the normal state.
Procedure
Step 1 Run the display board command to check whether the board meets the data plan requirement
(that is, check whether the board name and the ID of the slot housing the board are the same as
the data plan) and check the status of all the boards.
l If no board is lost and all the boards are normal, the operation is complete.
l If one or more boards are lost, insert the lost boards. Run the board add command to add
the boards to be inserted. Note that the types of the configured boards must be consistent
with the types of the actually-inserted boards. Run the board confirm command to confirm
the boards. Then, run the display board command to query the status of all the boards.
----End
Result
The status of all the boards is displayed as "Normal".
3.9 Loading the Script
This topic describes how to load the script file to configure the basic data of the device, which
is a preparation for the commissioning of the basic functions of the device.
Prerequisites
l The script file must be available. For the information on how to make a script, see A.2
Making a Script.
l The hardware must be installed and checked.
l The commissioning terminal must log in to the UA5000 successfully.
Precaution
Each command in the script file must end with an Enter character.
Procedure
Step 1 Open the script file and copy the commands in the file into the maintenance command line
interface (CLI).
----End
Result
All the commands in the script are automatically executed successfully.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 3 Stand-Alone Commissioning
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
60
To Next Page
Loading...
