Huawei UA5000 - Checking the Power Supply of the Power Board

CAUTION
The battery capacity parameters corresponding with different cabinets are different. You need
to configure in correct way. Otherwise, you may damage the battery.
Step 4 In the corresponding power mode, run the power battery command to configure the battery
parameters.
Table 3-13 lists the battery capacity of the different cabinets in the UA5000.
Table 3-13 Battery capacity of different cabinets
Cabinet Type Battery Capacity
ONU-F01E200 (Outdoor) 50 AH
ONU-F01E400 (Outdoor) 75 AH
ONU-F01D200 (Outdoor) 80 AH
ONU-F01D500 (Outdoor) 150 AH/184 AH
ONU-F01D1000 (Outdoor) 184 AH
ONU-F02A (Indoor) 100 AH
Step 5 In the corresponding power mode, run the power battery-test command to configure the battery
discharging parameters.
Step 6 In privilege mode, run the save command to save the related configuration. When the monitoring
module and the UA5000 device communicate with each other in the normal state, the configured
data take effect automatically.
Step 7 Disconnect the mains supply, and check whether the cabinet power system can switch to the
battery supply mode.
Step 8 Restore the mains supply, and check whether the cabinet power system can switch to the mains
supply mode.
----End
Result
l After the mains supply is disconnected, the cabinet power system switches to the battery
supply mode and the power supply is in the normal state.
l After the mains supply is restored, the cabinet power system switches to the mains supply
mode and the power supply is in the normal state.
3.4.4 Checking the Power Supply of the Power Board
This topic describes how to check whether the redundancy backup function of the PWX board
is in the normal state.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 3 Stand-Alone Commissioning
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
25