Huawei UA5000 - Tool Requirements

Checklist
Table 2-2 provides the checklist for checking the required software before the commissioning.
Table 2-2 Software checklist
No. Item Description
1 Software
package
Check whether the software package for the commissioning is
complete and the version is correct.
2 Software
commissioning
tools
Check whether the required software commissioning tools are
available. The commonly used commissioning tools are as
follows:
l HyperTerminal: Used for logging in to the UA5000
through the CLI. The tool is embedded in Windows.
l TFTP and FTP: Used for loading software, which can be
downloaded from http://support.huawei.com.
l Toolbox: Used for tracing signals. It is released with the
version.
2.3 Tool Requirements
This topic describes the tools required for the commissioning. You need to prepare and check
the required tools before the commissioning to facilitate the subsequent operations.
Checklist
Table 2-3 provides the checklist for checking the required tools before the commissioning.
Table 2-3 Tool checklist
No.
Item Description Remarks
1 Cables RS-232 serial port cable:
l One end is an RJ45 connector,
used for connecting to the
control board of the device.
l The other end is a DB-9 or
DB-25 female connector, used
for connecting to the
commissioning terminal. When
the maintenance terminal is a
PC, use the DB-9 female
connector.
Used for connecting the
commissioning terminal to the
UA5000 in the case of maintenance
through the serial port.
Crossover cable Used for connecting the
commissioning terminal to the
UA5000 in the case of maintenance
in the Telnet mode.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 2 Commissioning Preparations
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6