Huawei UA5000 - 7.5 Configuring EPS75-4815 AF Parameters

4.1 NMS Interconnection Commissioning
The administrator can maintain and manage the UA5000 in inband network management or
outband network management mode. This topic describes how to commission the
interconnection by considering the "iManager U2000 unified network management
system" (iManager U2000) as an example.
4.1.1 Commissioning the Outband NMS
This topic describes how to verify that the UA5000 can support the outband NMS through the
local maintenance network port (the outband NMS interface), so that the iManager U2000 can
maintain the device through this management channel.
Networking
Figure 4-1 shows that the iManager U2000 connects to the outband NMS interface of the PVMB
control board in the UA5000 through the IP network.
Figure 4-1 Networking for the outband NMS
COM
ETH1
PVMB
iManager U2000
UA5000
Router
ETH0
NOTE
l When the control board is PVMB, the iManager U2000 connects to the ETH0 maintenance network
port of the PVMB control board through the IP network in the independent upstream mode. The
iManager U2000 connects to the ETH1 service network port of the PVMB control board through the
IP network in the integrated upstream mode.
l When the control board is PVMD, the iManager U2000 connects to the ETH maintenance network
port of the active PVMD control board through the IP network in the independent upstream or the
integrated upstream mode.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 4 Commissioning the Interconnection
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
94