3.15 Checking the System Time
This topic describes how to check whether the system time, time zone, time stamp, and start and
end Daylight Saving Time (DST) of the UA5000 are consistent with the actual conditions.
Procedure
Step 1 Check the system time.
1. Run the display time command to check the current system time. If the current system time
is consistent with the local standard time, there is no need to modify the current system
time. If the current system time is inconsistent with the local standard time, perform the
following step b.
2. Run the time command to modify the system time.
Step 2 Check the system time zone.
1. Run the display timezone command to check the current system time zone. If the current
system time zone is consistent with the local standard time zone, there is no need to modify
the current system time zone. If the current system time zone is inconsistent with the local
standard time zone, perform the following step b.
2. Run the timezone command to modify the system time zone.
Step 3 Check the time stamp.
1. Run the display time time-stamp command to check the current system time stamp. If the
current system time stamp is consistent with the actual data plan, there is no need to modify
the current system time stamp. If the current system time stamp is inconsistent with the
actual data plan, perform the following step b.
NOTE
The format of the time on the SNMP interface between the NMS and the NE is classified into the
following two types: UTC time and local NE time. By default, the format of the time on the interface
between the NMS and the NE is the local NE time.
2. Run the time time-stamp command to modify the system time stamp.
Step 4 Check the start time and the end time of the Daylight Saving Time (DST).
1. Run the display time dst command to check the start time and the end time of the current
system DST. If the start time and the end time of the current system DST are consistent
with the actual ones, there is no need to modify the start time and the end time of the current
system DST. If the start time and the end time of the current system DST are inconsistent
with the actual ones, perform the following step b.
2. Run the time dst command to modify the start time and the end time of the system DST.
----End
Result
The system time, time zone, time stamp, and start and end DST are consistent with the actual
conditions.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 3 Stand-Alone Commissioning
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
84
To Next Page
Loading...
