EasyManua.ls Logo

Huawei UA5000 - 4 Commissioning the Interconnection

Huawei UA5000
137 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4 Commissioning the Interconnection
About This Chapter
The UA5000 is interconnected with other devices to meet the requirements for various services.
4.1 NMS Interconnection Commissioning
The administrator can maintain and manage the UA5000 in inband network management or
outband network management mode. This topic describes how to commission the
interconnection by considering the "iManager U2000 unified network management
system" (iManager U2000) as an example.
4.2 Commissioning the MG Interface
This topic describes how to commission the MG interface. The MG interface is an interface for
the communication between the UA5000 and the MGC. This interface can use the H.248 or
MGCP protocol. Before commissioning the service, you must commission the MG interface
successfully.
4.3 Commissioning the Interconnection with the SIP Interface
This topic describes how the UA5000 as the voice over IP gateway (VGW) communicates with
the IMS through the SIP interface.
4.4 Commissioning the Interconnection Between the Device and the Router
This topic describes how to check whether the UA5000 can normally communicate with the
router and whether the UA5000 can access the upper-layer device through the router.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 4 Commissioning the Interconnection
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
93

Table of Contents

Other manuals for Huawei UA5000

Related product manuals