Huawei UA5000 - Commissioning the Interconnection between the Device and the Router

Media IP 10.13.4.116
Transfer Mode UDP
Primary Proxy IP 1 10.13.4.110
Primary Proxy IP 2 -
Primary Proxy Port 5555
Secondary Proxy IP 1 10.13.4.120
Secondary Proxy IP 2 -
Secondary Proxy Port 5555
Proxy address mode IP
SIPProfile Index 1:profile2
Primary Proxy Domain Name -
Secondary Proxy Domain Name -
Home Domain Name UA5000.com
Description -
MG Domain Name huawei.com
Phone Context +86755
Register URI -
Conference Factory URI -
------------------------------------------------------------
Step 5 Reset the SIP interface.
huawei(config-if-sip-0)#reset
huawei(config-if-sip-0)#quit
Step 6 Save the data.
huawei(config)#save
----End
Result
After the display if-sip attribute command is executed to query the current attributes of the SIP
interface, it is found that the attributes of the SIP interface are the same as the configured
attributes.
4.4 Commissioning the Interconnection Between the Device
and the Router
This topic describes how to check whether the UA5000 can normally communicate with the
router and whether the UA5000 can access the upper-layer device through the router.
Service Requirements
In the network as shown in Figure 4-6, the UA5000 uses the PVMB board for upstream
transmission.
NOTE
For details about how to configure a router, see the related configuration guide.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 4 Commissioning the Interconnection
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
106