Huawei UA5000 - Page 115

Figure 4-6 Example network for commissioning the interconnection between the router and the
device
COM
ETH1
PVMB
Router
10.50.1.1
UA5000
LAN
PC
PC
PC
10.10.1.0/24
ETH0
Procedure
Step 1 Configure the IP address of the uplink port.
Configure the IP address of the uplink port to 10.50.1.10/24. The IP address of the uplink port
and the IP address of the gateway (that is, the IP address of the router port that is connected to
the UA5000) must be in the same network segment.
huawei(config)#interface eth
huawei(config-if-eth)#ip address 10.50.1.10 255.255.255.0 10.50.1.1 vlan_tag 1
huawei(config-if-eth)#quit
Step 2 Save the data.
huawei(config)#save
----End
Result
After the UA5000 is interconnected with the router successfully, you can ping IP address
10.10.1.0/24 from the UA5000.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 4 Commissioning the Interconnection
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
107