Huawei UA5000 - Setting the Default Overseas Parameters

Parameter
Index
Meaning Default Setting
11 Medium stream forwarding mode inside a device. 0:
device internal forwarding; 1: device external
forwarding
0: device internal
forwarding
12 Howler tone source. 0: FPGA; 1: DSP; 2: analog
subscriber board; 3: customer test board
0: FPGA
13 TEI check cycle 5 min
14 Whether to support the POTS GTC statistics. 0: not
support; 1: support
1: support
54 Power line alarm switch. 0: not support; 1: support 0: not support
55 Long-time call alarm duration. Multiple of 30 minutes. 0 min
A.4.2 Setting the Default Overseas Parameters
The default overseas parameter settings of the UA5000 are as follows:
Table A-4 Overseas parameters
Parameter
Index
Meaning Default Setting
0 Busy tone frequency configuration. 0: China (450 Hz);
1: Hongkong (480 + 620 Hz); 2: Reserved value
0: China (450 Hz)
1 Break duration of the busy tone (ms). Reference
standard: China 350 ms; Hongkong: 500 ms
350 ms
2 Ringing duration of the busy tone (ms). Reference
standard: China 350 ms; Hongkong: 500 ms
350 ms
3 Upper hooking threshold (ms). Reference standard:
China: 300 ms; Hongkong: 800 ms
300 ms
4 Lower hooking threshold (ms). Reference standard:
China: 100 ms; Hongkong: 100 ms
100 ms
5 Flag of sending pulse information signal or not after
processing the pulse signal from the switch. 0: not send
(Brazil standard); 1: send
1: send
6 Flag of switch sending initial ringing signals or not in
the calling line identification service. 0: not send (Brazil
standard); 1: send
1: send
7 Flag of whether access network (AN) using the pulse
polarity reversal unit or not. 0: not use; 1: use (Brazil
standard)
0: not use
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI A Additional Information
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
121