Huawei UA5000 - Page 130

Parameter
Index
Meaning Default Setting
8 Flag of whether AN using the resource unavailable unit
or not. 0: not use; 1: use (Brazil standard)
0: not use
9 Flag of AN sending LE off-hook signal or not in case
of call conflict. 0: not send; 1: send (Brazil standard)
0: not send
10 Flag of AN sending howler tone or not when the port is
busy or idle during the 112 howler tone test. 0: not send
(Hongkong standard); 1: send
1: send
11 Flag of AN conducting the dial tone test during the
circuit test. 0: not conduct; 1: conduct (Hongkong
standard)
0: not conduct
12 Width of the polarity reversed pulse 0
13 Delay in sending the Establish_Ack messages (ms) 0 ms
14 Delay in sending the called offhook messages (ms) 0 ms
15 Flag of sending the hotline phone busy tone. 0: send; 1:
not send
0: Send
16 Flag of AOCE. 0: Not stop the ringing; 1..20: duration
of stopping ringing (s)
0: Not stop the
ringing
17 NEC-PCMMUX pulse protection timer duration (ms) 0 ms
18 NEC-PCMMUX pulse tail timer duration (ms) 0 ms
19 Call restriction flag. 0: not restrict; 1: restrict 0: not restrict
20 Transmission enable issue flag. 0: not issue; 1: issue 0: not issue
21 CDI loop line check cycle (40~960s) 240 s
22 Radius packet Rx and Tx direction control. 0: positive
direction; 1: negative direction
0: positive
direction
23 CDI Z-extension first ring timer length (ms) 1000 ms
24 CDI Z-extension first ring break timer length (ms). 4000 ms
25 Flag of not processing ISDN deactive message from the
LE. 0: process; 1: not process
0: process
26 Flag of LE not sending reduce battery message. 0: send;
1: not send
0: send
27 Reserved parameters 65535
28 Hotline ring back tone parameters (0~15). For
configuring this parameter, refer to the user-defined
ringing types.
15
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI A Additional Information
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
122