Huawei UA5000 - Page 42

Configuration Flowchart
Figure 3-13 shows the flowchart for logging in to and configuring the system through the inband
management port in telnet mode.
Figure 3-13 Flowchart for logging in to and configuring the system through the inband
management port in telnet mode
End
Start
Configure IP address of
service network port
Set up configuration
environment
Run the telnet
program
Log in to the system
Run the telnet
program
Procedure
Step 1 Set up the configuration environment.
l If you log in to the UA5000 in the LAN inband management mode through telnet, set up a
network environment according to the networking shown in Figure 3-11.
l If you log in to the UA5000 in the WAN inband management mode through telnet, set up a
network environment according to the networking shown in Figure 3-12.
Step 2 Configure the IP addresses of the service network port.
In ETH mode, you can run the ip address command to configure the IP address of the service
network port.
huawei(config)#interface eth
huawei(config-if-eth)#ip address 10.10.20.10 255.255.255.0 10.10.20.1 vlan_tag 1
huawei(config-if-eth)#exit
Step 3 Run the telnet application.
Choose Start > Run from the main menu on the maintenance terminal. On the Open address
bar of the Run interface, enter telnet X.X.X.X (X.X.X.X indicates the IP address of the ETH1
port on the UA5000), as shown in Figure 3-14 (Windows is considered as an example), and
then click OK to display the remote login dialog box.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 3 Stand-Alone Commissioning
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
34