Operation Description
Set the upper temperature limit of the
EMU to a value lower than the ambient
temperature.
Check whether the alarm/event attributes including
the alarm/event severity and the alarm/event
occurrence time are correct and check whether the
alarm/event on the NMS is consistent with the
alarm/event on the maintenance terminal.
Restore the temperature threshold of
the EMU to the default value.
Check whether the alarm/event attributes including
the alarm/event severity and the alarm/event
occurrence time are correct and check whether the
alarm/event on the NMS is consistent with the
alarm/event on the maintenance terminal.
Set the upper humidity limit of the
EMU to a value lower than the ambient
temperature.
Check whether the alarm/event attributes including
the alarm/event severity and the alarm/event
occurrence time are correct and check whether the
alarm/event on the NMS is consistent with the
alarm/event on the maintenance terminal.
Restore the humidity threshold of the
EMU to the default value.
Check whether the alarm/event attributes including
the alarm/event severity and the alarm/event
occurrence time are correct and check whether the
alarm/event on the NMS is consistent with the
alarm/event on the maintenance terminal.
Remove/insert the fan tray. Check whether the alarm/event attributes including
the alarm/event severity and the alarm/event
occurrence time are correct and check whether the
alarm/event on the NMS is consistent with the
alarm/event on the maintenance terminal.
Switch over the active and the standby
control boards.
Log in to the system again and run the display
alarm history command on the commissioning
terminal to check whether the active and standby
switchover alarm exists in the history alarms.
NOTE
The alarm for the active and standby switchover is
reported after the active and standby switchover occurs.
Remove/insert the cables of the
subtending slave shelf.
Check whether the alarm/event attributes including
the alarm/event severity and the alarm/event
occurrence time are correct and check whether the
alarm/event on the NMS is consistent with the
alarm/event on the maintenance terminal.
Turn off/Turn on the switch of the
mains power supply.
Check whether the alarm/event attributes including
the alarm/event severity and the alarm/event
occurrence time are correct and check whether the
alarm/event on the NMS is consistent with the
alarm/event on the maintenance terminal.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 5 Maintenance and Management Commissioning
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
110
To Next Page
Loading...
