10. 3.10 Configuring the Networking Mode of the System
When the networking modes of the UA5000 are different, perform the operation to
configure the networking mode of the system to independent networking or integrated
access networking.
11. 3.11 Detecting the Power on the Optical Port
This topic describes how to detect the mean launched optical power and the actual input
optical power to check whether the transmit optical transceiver and the receive optical
transceiver are in the normal state.
12. 3.12 Checking the Status of the Uplink Port
This topic describes how to check the status of the uplink port to ensure that the
interconnection between the UA5000 and the upper layer device is in the normal state, thus
ensuring the normal communication.
13. 3.13 Changing the System Name
This topic describes how to customize the useful system name to differentiate UA5000s.
This facilitates the management of the UA5000.
14. 3.14 Configuring a System User
When accessing, configuring, and managing the UA5000, you need to add the system
operation users with different attributes. This topic describes how to add system operation
users and modify the attributes of the system operation users.
15. 3.15 Checking the System Time
This topic describes how to check whether the system time, time zone, time stamp, and
start and end Daylight Saving Time (DST) of the UA5000 are consistent with the actual
conditions.
16. 3.16 Commissioning the EMU
The UA5000 provides the function of monitoring various environment parameters (such
as the temperature, humidity, and power voltage) so that the device runs in the stable
environment. This topic describes how to commission the environment monitoring unit
(EMU).
17. 3.17 Checking the Auto-Save Settings
This topic describes how to check the settings of the auto-save function to prevent data loss
due to reboots.
18. 3.18 Saving the Data
This topic describes how to save the data into the flash memory to prevent data loss due to
reboots.
19. 3.19 Backing Up the System File
This topic describes how to back up the system file to prevent permanent data loss due to
the system failure. At the first office deployment or when the upgrade is complete, you
need to back up the database file and the configuration file to restore the system in the case
of the system failure.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 3 Stand-Alone Commissioning
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10
To Next Page
Loading...
