NOTE
l The baud rate of the HyperTerminal must be the same as the baud rate of the serial port on the
UA5000. By default, the baud rate of the serial port on the UA5000 is 9600 bit/s.
l If illegal characters are displayed on the HyperTerminal interface after you log in to the system,
it indicates that the baud rate of the HyperTerminal is different from the baud rate of the serial
port on the UA5000. In this case, you can modify the baud rate of the HyperTerminal and then
log in to the system again. The system supports the following baud rates: 9600bit/s, 19200bit/s,
38400bit/s, 57600bit/s, and 115200bit/s.
4. Click OK to display the HyperTerminal interface.
Step 3 Set the properties of the HyperTerminal.
1. Set the emulation type of the HyperTerminal.
Choose File > huawei Properties from the main menu on the HyperTerminal interface.
On the Settings tab page in the dialog box that is displayed, select VT100 or Auto
Detect as Emulation, as shown in the following figure. By default, Auto Detect is selected.
UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI 3 Stand-Alone Commissioning
Issue 04 (2012-06-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
30
To Next Page
Loading...
