104
On Screen Messages
Appendix
PPPoE server authentication has failed. Enter the correct password.
The remote party rejects answering. Check the settings of the remote party.
The remote terminal may not be registered
in gatekeeper. Contact the gatekeeper
administrator.
Contact the gatekeeper administrator regarding registration of the remote party
terminal.
Call not responded. Check connections of videoconferencing equipment at the remote party.
Temperature is abnormal. The power will
turn off.
The system is shutting down because abnormal temperature was detected.
Check the line interface or the IP address is
set correctly.
Check whether the line type and IP address settings in the LAN Setup menu are
correct.
No camera device is detected. The camera could not be detected for some reason.
GateKeeper error. Check the remote party address.
Gatekeeper does not respond. Check the gatekeeper settings.
Gatekeeper does not respond. User name and user number were entered, but the call could not proceed. Contact
the gatekeeper administrator or enter the IP address of the remote party and retry
the call.
Connection has been rejected as the data
exceeds the bandwidth of a gatekeeper.
The connection requirements exceed the bandwidth limitations of the gatekeeper.
Gatekeeper registration error. Check LAN
configuration.
Contact the gatekeeper administrator for information about gatekeeper registration
for the remote party terminal.
RGB input signal not acceptable. The RGB input signal in use is not compatible.
Communication ends. Steps for ending a videoconference were completed successfully.
Communication starts! Connection was established successfully and the videoconference can be started.
No more entries can be registered. The maximum number of entries for the Phone Book has been reached.
The system will be reset. The system is restarting.
The terminal with the specified IP address
does not exist, or the system is turned off.
Connection to the remote party could not be established. Check whether the
specified IP address is correct, or have the remote party turn the power on.
Please wait. Data are being saved.
Dialing your own number is invalid. Check the address for the remote party.
Now upgrading. Wait for a while. Be sure
not to turn off your system while upgrading.
The software version of a camera device, LCD, or other equipment is being
upgraded. Do not turn power off until the upgrade process is completed.
Still image saved to Memory Stick. The still image was saved on the “Memory Stick”.
The still image has been sent. Still image data were sent.
Incorrect still image format. Progressive
JPEG is not supported.
A JPEG file on the “Memory Stick” could not be decoded. The Progressive JPEG
format is not supported.
A still image is being sent or received. The
Data Solution Module (DSM) cannot be
used.
Wait until still image transmission is completed before using the Dual Stream Box
(DSB).
Still image transmission cancelled. The still image transmission was cancelled.
The still images were not sent. The still image sending attempt failed.
The software upgrade is complete. The
system will now restart.
The software upgrading process has completed normally.
Input title. Enter an index title.
Network congestion: Try again later. Available bandwidth is limited due to network congestion.
The network is heavily congested at the
moment. Some pictures may appear
distorted.
Data losses are occurring due to heavy network traffic. Video/audio quality may be
impaired.
Adjusting the white balance. Please wait. The white balance is being adjusted. When cancelled, the message will disappear,
but the camera adjustment process is not cancelled.
The Data Solution Module (DSM) cannot be
used.
The Dual Stream Box cannot be used.
The power will turn off. Please wait. The system is shutting down.
Name is not translated to IP address (DNS
error). Check LAN configuration.
Check the DNS settings.
Reference to DNS has failed. Check LAN
configuration.
When using a domain name server, the name for the remote party was entered,
but LAN connection could not be established. Enter the IP address and dial again.
Message Meaning
To Next Page
Loading...
