Huawei ViewPoint 8050 - Page 108

106
On Screen Messages
Appendix
Router is not supported. (Service
unavailable)
Make sure that you are using a router that is supported and that the router settings
are correct.
Router is not supported. (Failed to obtain
WAN IP address)
Make sure that you are using a router that is supported and that the router settings
are correct.
Router is not supported. (Port mapping
failed)
Make sure that you are using a router that is supported and that the router settings
are correct.
There are no open ports. Confirm the
router’s port settings.
Make sure that you are using a router that is supported and that the router settings
are correct.
Failing to automatically configure NAT
settings.
Make sure that you are using a router that is supported and that the router settings
are correct.
Cannot connect. Please try again later. Try calling again later.
Router is not supported. (Port mapping
delete failed)
Make sure that you are using a router that is supported and that the router settings
are correct.
Unable to communicate. (Port mapping
failed)
Make sure that you are using a router that is supported and that the router settings
are correct.
Communication with UPnP is not available.
(Timeout)
Make sure that you are using a router that is supported and that the router settings
are correct.
Communication with UPnP is not available.
(Busy)
Make sure that you are using a router that is supported and that the router settings
are correct.
Communication with UPnP is not available.
(Internal error)
Make sure that you are using a router that is supported and that the router settings
are correct.
Connection with the selected line interface
is not available in the current
communication mode.
Check the current communication mode.
Disconnected because reception of packets
from the far-end side has stopped.
Packets were not received properly.
Message Meaning